Taqueria Del Sol

Inspector notes: Observed black mold like residue on the interior walls of the ice machine in the main kitchen. Food contact surfaces must be kept clean in order to prevent contamination. CA pic was advised to clean and sanitize the ice machine as well as to establish a routine cleaning schedule to maintain clean and sanitary conditions.

Inspector notes: Observed the accumulation of food debris and grease on the floor in the main kitchen area. All physical facilities must be maintained clean and free of build up. CA advised PIC to clean the affected areas to prevent the accumulation of debris.

Inspector notes: Observed several TCS foods in the WIC with internal temps above 41F. (CA) Advised the PIC that TCS foods must be kept at 41F or lower. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below

Inspector notes: Observed TPHC being used but log not filled out for today or items marked with the time made or discard time. COS- food was removed. 511-6-1.04(6)(i) - Time as a Public Health Control (TPHC) (P, Pf, C) (i) Time as a Public Health Control. 1. Except as specified under paragraph 4 of this subsection, if time without temperature control is used as the public health control for a working supply of time/temperature control for safety food before cooking, or for ready-to-eat time/temperature control for safety food that is displayed or held for sale or service, written procedures shall be prepared in advance, maintained in the food service establishment, and made available to the regulatory authority upon request that specify: Pf (i) Methods of compliance with paragraphs 2(i) - (iii) or 3(i)...

Inspector notes: Observed a sanitizer bucket concentration exceeding 400ppm. 511-6-1.07(6)(g) - Chemical Sanitizers, Criteria (P) (g) Chemical Sanitizers, Criteria. Chemical sanitizers, including chemical sanitizing solutions generated on-site, and other chemical antimicrobials applied to food-contact surfaces shall: 1. Meet requirements specified in 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (Food-contact surface sanitizing solutions) P, or When ready for use, the end-use concentration of all quaternary chemicals in solution is not to exceed 400 ppm of active quaternary compound. COS- bucket was remade to 200ppm.

Inspector notes: Observed multiple TCS food items being held at 43-44 degrees in the WIC. COS- cooler was turned down and food was removed. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P

Inspector notes: Observed two employees in the main cook area with jewelry on their wrist. COS- jewelry was removed. 511-6-1.03(5)(g) - Jewelry (C) (g) Jewelry. Except for a plain ring such as a wedding band food employees may not wear jewelry including medical information jewelry on their arms and hands while preparing food.

Inspector notes: Observed cutting boards stained and with gashes. CA- cutting boards shall be resurfaced or replaced if they cannot be cleaned. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

Inspector notes: Observed debris inside the gaskets inside the coolers, observed the WIC fans dusty. CA- nonfood contact surfaces shall be cleaned. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Inspector notes: Observed a dead roach stuck on the inside of the RIC wall and observed a live bug. CA-observed pest control records from 8/27. Facility is in need of a deep clean. 511-6-1.07(5)(k) - Controlling Pests (Pf, C) (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by: 1. Routinely inspecting incoming shipments of food and supplies; 2. Routinely inspecting the premises for evidence of pests; 3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and 4. Eliminating harborage conditions.

Inspector notes: Observed visible light coming from the back door. CA- outer openings shall be protected. 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected. 1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors. 2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached struct...