Beat the Bomb Houston

General. time without temperature control. except as specified under subitem d of this item, when time without temperature control is used as the public health control for a working supply of time/temperature controlled for safety (tcs) food before cooking, or for ready to eat time/temperature controlled for safety (tcs) food that is displayed or held for service written procedures not prepared in advance, maintained in the food establishment / not made available to the regulatory authority upon request. these written procedures shall specify methods of compliance with subitems b[01]-[03] or c[01]-[05] of this item; and methods of compliance with section 20-21.03(b)(02) of this code for food that is prepared, cooked, and refrigerated before time is used as a public health control.

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) and ready to eat food stored at 41°f (5°c) for more than seven days. (corrected on site)

Time/temperature controlled for safety (tcs) food. except when time is used as a public health control as specified in section 20-21.02(a)(02) of this code, time/temperature controlled for safety (tcs) food shall be kept at an internal temperature of 41°f (05°c) or below or at a temperature of 135°f (57°c) or above during display and service, except that roasts cooked to a temperature and for a time specified in table 20-21.04-3 of this code or reheated as specified in table 20-21.04-01 of this code may be held for service at a temperature of 130°f (54°c) or above (corrected on site)

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Labeling of materials. working containers used for storing poisonous / toxic materials such as cleaners and sanitizers taken from bulk supplies not clearly / individually identified with the common name of the material.