Birdies Icehouse

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Utility line/duct installation. exposed utility service lines and pipes not installed in a way that does not obstruct or prevent cleaning of the walls and ceilings. utility service lines and pipes shall not be unnecessarily exposed on walls or ceilings in those areas listed in subsection (b) of this section. service lines behind counters used only for beverage preparation may be exposed on the inside counter walls if necessary for service and if kept to a minimum. if exposed in rooms or areas allowed in subsection (c) of this section, air conditioning / ventilation / heating ducts shall be of smooth rigid metal and designed with a circular cross-section.