Corner Mart #36/Chevron

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures. (corrected on site)

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Applicability of article; compliance; penalty for violation; variances, etc. operating a food service / processing establishment not conforming to requirements of article ii.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority. (corrected on site)

Cleaning frequency. kitchenware and food-contact surfaces of equipment not washed, rinsed, and sanitized after each use and following any interruption of operations during which time contamination may have occurred. (corrected on site)

A three-compartment sink not used when washing, rinsing and sanitization equipment / utensils manually except where a three-compartment sink is not required under section 20-21.11(b) of this code, in which case the procedure may be performed in the two-compartment sink.

Water under pressure. hot water is less 100°f (38°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.

Hand-washing sink installation. at least the minimum number of hand-washing sinks as required by applicable laws not provided. if approved and capable of removing the types of soils encountered in the food operations involved, automatic hand-washing facilities may be substituted for hand-washing lavatories in a food establishment that has at least one hand-washing sink.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Materials; general. sponges. sponges used in contact with cleaned and sanitized or in-use food-contact surfaces.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be easily cleanable.

Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Changes made in proposed arrangement of facilities not appearing on both original sets of plans and specifications.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Wiping cloths. moist cloths used for cleaning nonfood-contact surfaces of equipment such as counters, dining table tops and shelves not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Single-service articles. single-service and single-use articles not stored at least six inches (15 cm) above the floor on dollies / pallets / racks / skids designed as specified under section 20-21.03(a)2b of this code / not kept in closed cartons that protect them from contamination, except for automatic fire protection sprinkler heads that may be required by law.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.

Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Changes made in proposed arrangement of facilities not appearing on both original sets of plans and specifications.