Corner Stop

Applicability of article; compliance; penalty for violation; variances, etc. permit holder / person in charge of the food establishment / mobile food unit not in compliance in accordance with provisions of article ii concerning food storage / food preparation / food display / training of employees in basic food safety principles including allergy awareness / not ensuring that food and conditional employees are informed of their responsibility to report information regarding health and activities as they relate to diseases that are transmissible through food / not ensuring written procedures and plans are developed by the food establishment are maintained / implemented. (corrected on site)

Special requirements. manufactured food. all food manufactured, processed, or packaged in commercial food processing establishments or commissaries not labeled according to all applicable laws as defined in tfer 228.78 and 228.79.

Refrigerated storage. refrigeration facilities. the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of the mechanically refrigerated unit and designed to be easily readable.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Storage. glasses and cups not stored inverted / other stored utensils not covered or inverted, wherever practical.

Water under pressure. hot water is less 100°f (38°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment. (corrected on site)

Hand-washing sink installation. hand-washing sink used for purpose other than hand-washing as specified in section 20-21.08(b) of this code.

Hand-washing sink supplies. supply of hand-cleansing liquid / powder / bar soap not available at each hand-washing sink or group of two adjacent hand-washing sinks. (corrected on site)

Maintaining refuse areas and enclosures. storage area / enclosure for refuse / recyclables / returnables not maintained free of items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer used, as specified in section 20-21.28(a)(03) / not maintained clean.

Openings. openings to the outside not effectively protected against the entrance of rodents.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not kept clean.

Signs clearly stating that smoking is prohibited within not conspicuously posted at every entrance to a public place.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Special requirements. manufactured food. all food manufactured, processed, or packaged in commercial food processing establishments or commissaries not labeled according to all applicable laws as defined in tfer 228.78 and 228.79.

Refrigerated storage. refrigeration facilities. the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of the mechanically refrigerated unit and designed to be easily readable.

Toilet fixtures. toilet room not provided with at least one covered waste receptacle.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Openings. openings to the outside not effectively protected against the entrance of rodents.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.