Fast Fuel
Last inspected: Oct 31, 2025
82
Score
Fast Fuel has only two inspections on file, a thin record to work from. On Oct 31, 2025, the health department conducted the most recent visit. A low risk tier reflects an inspection that turned up minimal issues.
Things are looking better lately, with recent visits averaging around four violations compared to roughly 11 violations earlier on.
The pattern that stands out is “using chemicals for sanitization”, which has been cited two times.
That's lower than the typical Houston restaurant, which scores around 88. The record reflects steady performance over time.
2
Inspections
0
Critical latest
0
Major latest
4
Minor latest
Inspection History
Oct 31, 2025
Routine
4 minor violations.
View 4 violations
Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.
20-21.12(g)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.
20-21.23(b)
82
Oct 16, 2025
Routine
11 minor violations. 1 corrected on site.
View 11 violations
Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.
20-21.03(b)(01)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.
20-21.12(g)
Water under pressure. hot water is less 100°f (38°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.
(corrected on site)
20-21.15(c)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Toilet room. toilet room not provided with tight-fitting / self-closing / solid doors, which shall be closed except during cleaning or maintenance except that this requirement does not apply to a toilet room that is located outside a food establishment and does not open directly into the food establishment such as a toilet room that is provided by the management of a shopping mall or stadium-type facilities.
20-21.18(c)
Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.
20-21.19(c)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
20-21.20(a)(03)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
58
Frequently Asked Questions
When was Fast Fuel last inspected?
The most recent health inspection at Fast Fuel on file is from Oct 31, 2025. The public record contains two inspections in total.
What is the most common violation at Fast Fuel?
Across the inspection record, “using chemicals for sanitization” has been cited two times, more than any other issue at Fast Fuel.
How does Fast Fuel compare to other restaurants in Houston?
Fast Fuel most recently scored 82 out of 100, which is lower than the Houston average of 88.
Has Fast Fuel's inspection record improved over time?
Yes. Recent inspections at Fast Fuel have averaged around four violations per visit, down from roughly 11 earlier in the record.
What does a low risk rating mean?
A low risk rating at Fast Fuel means inspectors found minimal or no significant issues at the most recent visit. Most facilities at this tier have a clean recent inspection report.
Nearby Restaurants