Gasmer Food Mart

5560 Gasmer Dr, Houston, TX 77035
Grocery / Market
Last inspected: Dec 18, 2025
52
Score
High Risk

The Gasmer Food Mart, located at 5560 Gasmer Dr in Houston, TX, underwent a high-risk inspection on December 18, 2025, with a score of 52. This inspection identified 13 minor violations, including issues with the internal temperature of time/temperature controlled for safety foods, bulk food display, and plumbing fixture installation. While this recent inspection indicated several areas needing attention, the facility has a historical pattern of mostly low-risk inspections across its eight recorded evaluations.

8
Inspections
0
Critical latest
0
Major latest
13
Minor latest
Inspection History
Dec 18, 2025
Complaint (003)
13 minor violations. 2 corrected on site.
View 13 violations
General. the internal temperature of time/temperature controlled for safety (tcs) food not maintained at 41°f (05°c) or below or 135°f (57°c) or above at all times, except as otherwise provided in this article or unless a packaged product is so labeled as exempted and approved by the appropriate state or federal health authority. (corrected on site)
20-21.02(a)(01)
Bulk food display, service. the sale of unpackaged food that is displayed and sold in bulk from a self-service container is authorized, provided that the self-service container has a tight-fitting lid that is securely attached to the container and kept closed except during service or refill; the container, lid and any other utensil are constructed of nontoxic materials that provide for easy cleaning and proper repair; a utensil equipped with a handle is provided and used for dispensing of food; and a conspicuous sign instructing the customer on the proper dispensing procedure is posted in the immediate display area.
20-21.05(i)(01)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Materials; general. all equipment and utensils not maintained in good repair.
20-21.10(a)
Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.
20-21.11(a)(08)c[04]
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.
20-21.12(g)
Single-service articles. single-service and single-use articles not handled / displayed / dispensed in a manner that prevents contamination of surfaces that may come in contact with food or with the mouth of the user.
20-21.14(c)(02)
Hand-washing sink supplies. when disposable towels are used, easily cleanable waste receptacles not conveniently located near the hand-washing facilities.
20-21.19(c)
Hand-washing signage. sign / icon / poster that notifies food employees to wash their hands not provided at all hand-washing sinks used by food employees / not clearly visible to food employees. (corrected on site)
20-21.19(g)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
20-21.20(a)(03)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
52
Nov 10, 2025
Routine
1 minor violation.
View 1 violation
Floor junctures. when allowed in this subsection, the juncture between walls and floors presenting an open seam of more than one-thirty-second of an inch.
20-21.22(f)
95
Nov 3, 2025
Routine
6 minor violations.
View 6 violations
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
General. food establishment and all parts of the property used in connection with operations of the establishment not kept free of litter and items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer in use.
20-21.28(a)(01)
Food establishment construction / remodeling / alterations begun before submitting properly prepared plans / specifications for approval.
20-25(a)
Grease traps. grease trap not located to be easily accessible for cleaning / operation / maintenance.
20-21.17(d)
General. plumbing not sized / installed / maintained according to applicable laws.
20-21.17(a)
Utility line/duct installation. exposed utility service lines and pipes not installed in a way that does not obstruct or prevent cleaning of the walls and ceilings. utility service lines and pipes shall not be unnecessarily exposed on walls or ceilings in those areas listed in subsection (b) of this section. service lines behind counters used only for beverage preparation may be exposed on the inside counter walls if necessary for service and if kept to a minimum. if exposed in rooms or areas allowed in subsection (c) of this section, air conditioning / ventilation / heating ducts shall be of smooth rigid metal and designed with a circular cross-section.
20-21.23(f)
74
Jan 15, 2025
Routine
3 minor violations.
View 3 violations
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.
20-21.23(b)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
86
Dec 12, 2024
Routine
No violations found.
100
Dec 11, 2024
Routine Inspection (001)
10 minor violations. 2 corrected on site.
View 10 violations
Condemnation and disposition of contaminated food. tagged food / equipment used/not held pursuant pending disposition. (corrected on site)
20-02
8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.
20-20(c)
Inspections; reports. food establishment owner / operator / person in charge resumed operation before conditions responsible for ceasing operations no longer exist. (corrected on site)
20-20(h)
Materials; general. all equipment and utensils not maintained in good repair.
20-21.10(a)
Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.
20-21.12(g)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
20-21.20(a)(03)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Sanitation poster not conspicuously posted in area accessible to all employees / not conforming to all requirements.
20-26(c)
\"no smoking\" signs or the international \"no smoking\" symbol not clearly and conspicuously posted in a public place where smoking is prohibited
21-244(a)
61
Dec 6, 2024
Reinspection (002)
2 minor violations.
View 2 violations
Applicability of article; compliance; penalty for violation; variances, etc. operating a food service / processing establishment not conforming to requirements of article ii.
20-19(b)
Water under pressure. hot water is less 100°f (38°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.
20-21.15(c)
90
Dec 5, 2024
Routine Inspection (001)
10 minor violations. 2 corrected on site.
View 10 violations
Applicability of article; compliance; penalty for violation; variances, etc. operating a food service / processing establishment not conforming to requirements of article ii.
20-19(b)
Refrigerated storage. cold storage of foods. time/temperature controlled for safety (tcs) food not maintained at 41°f (5°c) in cold storage. (corrected on site)
20-21.03(b)(09)
Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.
20-21.12(g)
Water under pressure. hot water is less 100°f (38°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.
20-21.15(c)
Toilet room. toilet room not provided with tight-fitting / self-closing / solid doors, which shall be closed except during cleaning or maintenance except that this requirement does not apply to a toilet room that is located outside a food establishment and does not open directly into the food establishment such as a toilet room that is provided by the management of a shopping mall or stadium-type facilities.
20-21.18(c)
Hand-washing sink installation. hand-washing sink used for purpose other than hand-washing as specified in section 20-21.08(b) of this code. (corrected on site)
20-21.19(a)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.
20-21.22(a)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Changes made in proposed arrangement of facilities not shown / not reviewed on revised plans and specifications before changes were made.
20-25(a)
61