Golden Chick

Applicability of article; compliance; penalty for violation; variances, etc. permit holder / person in charge of the food establishment / mobile food unit not in compliance in accordance with provisions of article ii concerning food storage / food preparation / food display / training of employees in basic food safety principles including allergy awareness / not ensuring that food and conditional employees are informed of their responsibility to report information regarding health and activities as they relate to diseases that are transmissible through food / not ensuring written procedures and plans are developed by the food establishment are maintained / implemented. (corrected on site)

General. when time without temperature control is used as the public health control up to a maximum of four hours: food was not marked or otherwise identified to indicate the time that is four hours past the point in time when the food was removed from temperature control. (corrected on site)

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”. (corrected on site)

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Cleaning frequency. food-contact surfaces of grills, griddles, and similar cooking devices and the cavities and door seals of microwave ovens not cleaned at least once a day; except that this shall not apply to hot oil cooking and hot oil filtering equipment if it is cleaned as specified in subsection (f) of this section. the food-contact surfaces of all cooking equipment shall be kept free of crusted grease deposits and other accumulated soil.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Hand-washing sink installation. hand-washing sink not accessible to employees at all times.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Maintaining refuse areas and enclosures. storage area / enclosure for refuse / recyclables / returnables not maintained free of items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer used, as specified in section 20-21.28(a)(03) / not maintained clean.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Special ventilation. filters not cleaned at sufficient frequency to prevent accumulation.

General. food establishment and all parts of the property used in connection with operations of the establishment not kept free of litter and items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer in use. (corrected on site)

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Toilet fixtures. toilet fixture not kept clean / not in good repair.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Materials; general. all equipment and utensils not maintained in good repair.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Wiping cloths. moist cloths used for wiping food spills on kitchenware and food-contact surfaces of equipment not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses.

Cleaning frequency. equipment, food-contact surfaces, and utensils not clean to sight and touch.

Temperature measuring device, food. no temperature measuring device provided to assure attainment / maintenance of proper internal / holding refrigerated temperature of time/temperature controlled for safety (tcs) food.

Dispensing utensils. no suitable dispensing utensils provided for employees / consumers during pauses in food preparation / dispensing. (corrected on site)

Manual rinsing. washed utensils and equipment not rinsed so that abrasives are removed and cleaning chemicals are removed or diluted through the use of water or detergent sanitizer solution by using one of the following procedures: use of a distinct, separate water rinse after washing and before sanitizing when using a three-compartment sink or alternative manual utensil-washing equipment equivalent to a three-compartment sink as specified in tfer 228.107(b)(03); or a three-step washing, rinsing, and sanitizing procedure in a mechanical equipment washing system for cip equipment / use of a detergent-sanitizer as specified under section 20-21.12(h) of this code if using an alternative manual utensil-washing equipment that is approved for use with a detergent-sanitizer as specified in tfer 228.107(b)(03) or a mechanical equipment washing system for cip equipment / use of a nondistinct water rinse that is integrated in the hot water sanitization immersion step of a two-compartment sink operation / when using a dishwashing machine that does not recycle the sanitizing solution as specified in subitem e of this item or alternative manual utensil-washing equipment such as sprayers, use of a nondistinct water rinse that is integrated in the application of the sanitizing solution and washed immediately after each application / when using a dishwashing machine that recycles the sanitizing solution for use in the next wash cycle, use of a nondistinct water rinse that is integrated in the application of the sanitizing solution.

Hand-washing sink installation. hand-washing sink not accessible to employees at all times.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means. (corrected on site)

Applicability of article; compliance; penalty for violation; variances, etc. operating a food service / processing establishment not conforming to requirements of article ii.

Materials; general. all equipment and utensils not maintained in good repair.

Containers. in containers designed with drains, drain plugs not in place at all times, except during cleaning.

Maintaining refuse areas and enclosures. storage area / enclosure for refuse / recyclables / returnables not maintained free of items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer used, as specified in section 20-21.28(a)(03) / not maintained clean.

Controlling pests, generally. effective measures intended to eliminate the presence of rodents, flies, cockroaches, and other insects on the premises not utilized.

Signs clearly stating that smoking is prohibited within not conspicuously posted at every entrance to a public place.