Hotel Zaza Houston Museum District
Last inspected: Jan 8, 2026
100
Score
Hotel Zaza Houston Museum District, located at 5701 Main St, Houston, TX, has a history of low-risk inspections. Their most recent inspection on January 8, 2026, resulted in a score of 100 with no violations recorded. Across six scored inspections, the facility has consistently maintained a low-risk status.
6
Inspections
0
Critical latest
0
Major latest
0
Minor latest
Inspection History
Jan 8, 2026
Routine
No violations found.
100
Dec 19, 2025
Reinspection (002)
25 minor violations. 11 corrected on site.
View 25 violations
Refrigerated storage. cold storage of foods. time/temperature controlled for safety (tcs) food not maintained at 41°f (5°c) in cold storage.
(corrected on site)
20-21.03(b)(09)
General. container of food not stored a minimum of 6 inches above the floor.
(corrected on site)
20-21.03(a)(02)
Refrigerated storage. ice intended for human consumption shall not be used as a medium for cooling stored food, food containers, or food utensils, but may be used for cooling tubes conveying beverages or beverage ingredients to a dispenser head.
(corrected on site)
20-21.03(b)(05)
Cooking time/temperature controlled for safety (tcs) foods. permit holder failed to inform consumers of the significantly increased risk of consuming foods by way of a disclosure and reminder, as specified in items (06) and (07) of this subsection by using brochures / deli case or menu advisories / label statements / table tents / placards / other effective written means when animal food such as beef / eggs / fish / lamb / milk / pork / poultry / shellfish is served or sold raw / undercooked / without otherwise being processed to eliminate pathogens either in ready to eat form or as an ingredient in another ready to eat food (except as specified in items (03) and (08) of this subsection).
20-21.04(c)(05)
Dispensing utensil not stored in non-time/temperature controlled for safety (tcs) food with the handle above the top of the food within the covered container / equipment.
(corrected on site)
20-21.05(f)(06)
Dispensing utensils not stored in running water with sufficient velocity to flush / drain particulates (such as mashed potatoes or ice cream).
(corrected on site)
20-21.05(f)(03)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Materials; general. multi-use equipment and utensils not designed, constructed and repaired with safe materials, including finishing materials / not corrosion-resistant and nonabsorbent / not smooth, easily cleanable and durable under conditions of normal use.
20-21.10(a)
Cleaning frequency. kitchenware and food-contact surfaces of equipment not washed, rinsed, and sanitized after each use and following any interruption of operations during which time contamination may have occurred.
(corrected on site)
20-21.11(a)(02)
Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.
(corrected on site)
20-21.11(a)(08)c[04]
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Wiping cloths. moist cloths used for cleaning nonfood-contact surfaces of equipment such as counters, dining table tops and shelves not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses.
(corrected on site)
20-21.11(c)(03)
Cleaning frequency. food-contact surfaces of grills, griddles, and similar cooking devices and the cavities and door seals of microwave ovens not cleaned at least once a day; except that this shall not apply to hot oil cooking and hot oil filtering equipment if it is cleaned as specified in subsection (f) of this section. the food-contact surfaces of all cooking equipment shall be kept free of crusted grease deposits and other accumulated soil.
(corrected on site)
20-21.11(a)(06)
Thermometers. machine or water line mounted numerically scaled indicating thermometers accurate to 3°f not provided to indicate the temperature of the water in each wash and rinse tank and the temperature of the water as it enters the hot water sanitizing final rinse manifold or in the chemical sanitizing solution tank. thermometers dually scaled in celsius and fahrenheit may alternatively be provided if designed to be easily readable and accurate to 1.05°c in the intended range of use. water temperature measuring devices on mechanical dishwashing machines shall have a numerical scale, printed record, or digital readout in increments no greater that 1°c or 2°f in the intended range of use.
20-21.13(c)
Single-service articles. single-service and single-use articles not stored at least six inches (15 cm) above the floor on dollies / pallets / racks / skids designed as specified under section 20-21.03(a)2b of this code / not kept in closed cartons that protect them from contamination, except for automatic fire protection sprinkler heads that may be required by law.
20-21.14(c)(01)
Prohibited storage area. food equipment / utensils / laundered linens / single-service and single-use articles shall not be stored in locker rooms / toilet rooms / vestibules / garbage rooms / mechanical rooms / under sewer lines that are not shielded to intercept potential drips / under open stairwells / under other sources of contamination is prohibited except that laundered linens and single-service and single-use articles that are packaged or in a facility such as a cabinet may be stored in a locker room.
20-21.14(d)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Hand-washing sink installation. hand-washing sink used for purpose other than hand-washing as specified in section 20-21.08(b) of this code.
20-21.19(a)
Hand-washing signage. sign / icon / poster that notifies food employees to wash their hands not provided at all hand-washing sinks used by food employees / not clearly visible to food employees.
20-21.19(g)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Removing dead or trapped birds / insects / rodents / other pests. dead or trapped birds / insects / rodents / other pests not removed from control devices and the premises at a frequency that prevents the accumulation or attraction of pests and minimizes exposure to decomposing remains.
(corrected on site)
20-21.21(d)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.
20-21.22(a)
Cleaning physical facilities. general. floor mats / duckboards / walls / ceilings / attached equipment and decorative materials not kept clean. only dustless methods of cleaning floors and walls shall be used, such as vacuum cleaning, wet cleaning, or the use of dust-arresting sweeping compounds with brooms.
20-21.23(i)(01)
Covering material installation. wall and ceiling covering materials not attached and sealed so as to be easily cleanable.
20-21.23(h)
General. at least 20 foot-candles (220 lux) of light not provided at a distance of 30 inches (75 mm) above the floor in areas used for hand-washing / utensil-washing / equipment and utensil storage / in toilet rooms.
(corrected on site)
20-21.24(a)
29
Apr 25, 2025
Routine
No violations found.
100
Apr 22, 2025
Routine Inspection (001)
9 minor violations. 2 corrected on site.
View 9 violations
Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.
20-21.03(b)(01)
Materials; general. all equipment and utensils not maintained in good repair.
20-21.10(a)
Materials; general. single-service and single-use articles. single-service articles / single-use articles reused.
20-21.10(a)(05)
Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.
20-21.11(a)(08)c[04]
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Water under pressure. food establishment operating without hot and/or cold water under pressure. hot and/or cold water not available at establishment
(corrected on site)
20-21.15(c)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.
20-21.22(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
(corrected on site)
20-21.23(a)
64
Apr 17, 2025
Routine
No violations found.
100
Feb 5, 2025
Routine
3 minor violations.
View 3 violations
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
General. plumbing not sized / installed / maintained according to applicable laws.
20-21.17(a)
General. food establishment and all parts of the property used in connection with operations of the establishment not kept free of litter and items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer in use.
20-21.28(a)(01)
86
Nearby Restaurants