Pause & Go #2
Last inspected: Sep 11, 2025
100
Score
There aren't many inspections to draw from yet: just two so far. Inspectors last stopped by on Sep 11, 2025. Diners can read the low risk label as a sign that recent inspections have gone well.
The picture has improved over the last few visits: recent inspections have averaged around zero violations, down from roughly 11 violations earlier in the record.
Restaurants in Houston average 88, so Pause & Go #2 is doing better than most peers. The full picture is one of consistent compliance.
2
Inspections
0
Critical latest
0
Major latest
0
Minor latest
Inspection History
Sep 11, 2025
Routine
No violations found.
100
Aug 27, 2025
Routine
11 minor violations.
View 11 violations
Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.
20-21.03(b)(01)
Materials; general. all equipment and utensils not maintained in good repair.
20-21.10(a)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Single-service articles. single-service and single-use articles not stored at least six inches (15 cm) above the floor on dollies / pallets / racks / skids designed as specified under section 20-21.03(a)2b of this code / not kept in closed cartons that protect them from contamination, except for automatic fire protection sprinkler heads that may be required by law.
20-21.14(c)(01)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.
20-21.19(c)
Hand-washing signage. sign / icon / poster that notifies food employees to wash their hands not provided at all hand-washing sinks used by food employees / not clearly visible to food employees.
20-21.19(g)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.
20-21.23(a)
Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.
20-21.23(b)
Utility line/duct installation. exposed utility service lines and pipes not installed in a way that does not obstruct or prevent cleaning of the walls and ceilings. utility service lines and pipes shall not be unnecessarily exposed on walls or ceilings in those areas listed in subsection (b) of this section. service lines behind counters used only for beverage preparation may be exposed on the inside counter walls if necessary for service and if kept to a minimum. if exposed in rooms or areas allowed in subsection (c) of this section, air conditioning / ventilation / heating ducts shall be of smooth rigid metal and designed with a circular cross-section.
20-21.23(f)
58
Frequently Asked Questions
When was Pause & Go #2 last inspected?
The most recent health inspection at Pause & Go #2 on file is from Sep 11, 2025. The public record contains two inspections in total.
How does Pause & Go #2 compare to other restaurants in Houston?
Pause & Go #2 most recently scored 100 out of 100, which is higher than the Houston average of 88.
Has Pause & Go #2's inspection record improved over time?
Yes. Recent inspections at Pause & Go #2 have averaged around zero violations per visit, down from roughly 11 earlier in the record.
What does a low risk rating mean?
A low risk rating at Pause & Go #2 means inspectors found minimal or no significant issues at the most recent visit. Most facilities at this tier have a clean recent inspection report.
Nearby Restaurants