S&B Shack

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

General. the internal temperature of time/temperature controlled for safety (tcs) food not maintained at 41°f (05°c) or below or 135°f (57°c) or above at all times, except as otherwise provided in this article or unless a packaged product is so labeled as exempted and approved by the appropriate state or federal health authority. (corrected on site)

General. bulk food removed from original container not stored in a container identifying the food by common name.

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.

Temperature measuring device, food. food temperature measuring devices accurate to ±02°f in the intended range of use not provided / not used to assure attainment and maintenance of proper internal cooking, holding, or refrigeration temperatures of all time/temperature controlled for safety (tcs) food if the thermometers are scaled only in fahrenheit. if the thermometers are scaled in celsius or dually scaled, they shall be accurate to ±01°c in the intended range of use. a temperature measuring device with a suitable small-diameter probe that is designed to measure the temperature of thin masses not provided / not readily accessible to accurately measure the temperature in thin foods, such as meat patties and fish fillets.

Materials; general. all equipment and utensils not maintained in good repair.

Materials; general. single-service and single-use articles. single-service articles / single-use articles reused.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Containers. garbage / recyclables / returnables / refuse not kept in durable / easily cleanable / insect-proof and rodent-proof containers that do not leak and do not absorb liquids. plastic bags and wet-strength paper bags may be used to line the containers, and they may be used for storage inside the food establishment.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Presence and use, restrictions, conditions of use. poisonous / toxic materials unnecessary for the operation / maintenance of the establishment / cleaning and sanitization of equipment and utensils / control of insects and rodents are prohibited in the food establishment; provided, this requirement does not apply to packaged poisonous / toxic materials that are for retail sale. restricted use pesticides specified in item (03)c of this subsection shall meet the requirements specified in 40 cfr 152, subpart i, classification of pesticides.

Cleaning equipment storage. after use, mops not placed in a position that allows them to air-dry without soiling walls / equipment / supplies.

Signs clearly stating that smoking is prohibited within not conspicuously posted at every entrance to a public place.