Santa Maria Hostel

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Controlling pests, generally. the presence of insects, rodents, and other pests shall be controlled to eliminate their presence within the physical facility and its contents and on the contiguous land or property under the control of the permit holder by routinely inspecting incoming shipments of food and supplies.\r\n

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Cross contamination. except as specified in subitem c of this item, food not protected from cross contamination by separating raw animal foods during storage, preparation, holding and display from: raw ready to eat foods including other raw animal food such as fish for sushi or molluscan shellfish or other raw ready to eat food such as vegetables; cooked ready to eat foods. frozen, commercially processed and packaged raw animal food may be stored or displayed with or above frozen, commercially processed and packaged, ready to eat food. (corrected on site)

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Maintaining refuse areas and enclosures. storage area / enclosure for refuse / recyclables / returnables not maintained free of items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer used, as specified in section 20-21.28(a)(03) / not maintained clean.

Removing dead or trapped birds / insects / rodents / other pests. dead or trapped birds / insects / rodents / other pests not removed from control devices and the premises at a frequency that prevents the accumulation or attraction of pests and minimizes exposure to decomposing remains.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Wiping cloths. moist cloths used for cleaning nonfood-contact surfaces of equipment such as counters, dining table tops and shelves not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses. (corrected on site)

Cleaning frequency. food-contact surfaces of grills, griddles, and similar cooking devices and the cavities and door seals of microwave ovens not cleaned at least once a day; except that this shall not apply to hot oil cooking and hot oil filtering equipment if it is cleaned as specified in subsection (f) of this section. the food-contact surfaces of all cooking equipment shall be kept free of crusted grease deposits and other accumulated soil.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Controlling pests, generally. the presence of insects, rodents, and other pests shall be controlled to eliminate their presence within the physical facility and its contents and on the contiguous land or property under the control of the permit holder by routinely inspecting the premises for the evidence of pests.\r\n

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not kept clean. (corrected on site)

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”. (corrected on site)

Wiping cloths. moist cloths used for cleaning nonfood-contact surfaces of equipment such as counters, dining table tops and shelves not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses. (corrected on site)

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Controlling pests, generally. the presence of insects, rodents, and other pests shall be controlled to eliminate their presence within the physical facility and its contents and on the contiguous land or property under the control of the permit holder by eliminating harborage conditions.\r\n (corrected on site)

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

General. equipment / utensils not in current use not stored in a clean and sanitary condition.