Taco Cabana #234

Materials; general. all equipment and utensils not maintained in good repair.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Hair restraint. while handling food or utensils, food employees not wearing effective hair restraints and clothing that covers body hair to prevent the contamination of food or food-contact surfaces. an effective hair restraint means any cap / hat / hair net made of fabric / cord / plastic / paper that effectively covers and holds hair in place. the use of effective hair restraints also applies to any exposed scalp or facial hair where there is the potential for contamination of food or food-contact surfaces. an effective hair restraint shall also be used in the partial or complete absence of scalp hair to preclude touching of the scalp and returning to food handling without hand-washing. facial hair restraints are not be required when facial hair is well-groomed and trimmed. (corrected on site)

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.