Tacos El Vaquero Arre Lulu

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Refrigerated storage. cold storage of foods. time/temperature controlled for safety (tcs) food not maintained at 41°f (5°c) in cold storage. (corrected on site)

Materials; general. all equipment and utensils not maintained in good repair.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Materials; general. all equipment and utensils not maintained in good repair.

Refrigerated storage. cold storage of foods. time/temperature controlled for safety (tcs) food not maintained at 41°f (5°c) in cold storage. (corrected on site)

Dispensing utensils. no suitable dispensing utensils provided for employees / consumers during pauses in food preparation / dispensing.

Dispensing utensils not stored in running water with sufficient velocity to flush / drain particulates (such as mashed potatoes or ice cream). (corrected on site)

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

General. the internal temperature of time/temperature controlled for safety (tcs) food not maintained at 41°f (05°c) or below or 135°f (57°c) or above at all times, except as otherwise provided in this article or unless a packaged product is so labeled as exempted and approved by the appropriate state or federal health authority. (corrected on site)

General. container of food not stored a minimum of 6 inches above the floor.

Temperature measuring device, food. food temperature measuring devices accurate to ±02°f in the intended range of use not provided / not used to assure attainment and maintenance of proper internal cooking, holding, or refrigeration temperatures of all time/temperature controlled for safety (tcs) food if the thermometers are scaled only in fahrenheit. if the thermometers are scaled in celsius or dually scaled, they shall be accurate to ±01°c in the intended range of use. a temperature measuring device with a suitable small-diameter probe that is designed to measure the temperature of thin masses not provided / not readily accessible to accurately measure the temperature in thin foods, such as meat patties and fish fillets.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Materials; general. all equipment and utensils not maintained in good repair.

Hand-washing sink supplies. when disposable towels are used, easily cleanable waste receptacles not conveniently located near the hand-washing facilities.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Attachments. decorative materials in other than consumer areas attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Storage. outside storage areas / enclosures not constructed of durable and cleanable material / not large enough to store the garbage / recyclables / returnables / refuse containers that accumulate / not kept clean.