Taqueria Tepatitlan
Last inspected: Oct 28, 2025
55
Score
Going back to 2024, Taqueria Tepatitlan has four inspections in the public record. The latest inspection on file is from Oct 28, 2025. When a facility lands in medium risk territory, it usually means a mixed inspection result.
The trend has not been favorable: recent inspections average around 12 violations each, up from closer to six violations before.
“Plumbing fixture installation” accounts for the largest share of issues, appearing two times across the record.
The city-wide average sits at 88, which Taqueria Tepatitlan's 55 doesn't quite reach. The full record sits in fairly typical territory for a working restaurant.
4
Inspections
0
Critical latest
0
Major latest
12
Minor latest
Inspection History
Oct 28, 2025
Reinspection (002)
12 minor violations. 2 corrected on site.
View 12 violations
Refrigerated storage. rapid cooling temperatures. time/temperature controlled for safety (tcs) food not cooled from 135°f (21° c) to 41°f (5°c) or below within 6 hours.
20-21.03(b)(02)a
Materials; general. multi-use equipment and utensils not designed, constructed and repaired with safe materials, including finishing materials / not corrosion-resistant and nonabsorbent / not smooth, easily cleanable and durable under conditions of normal use.
20-21.10(a)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Hand-washing sink installation. hand-washing sink used for purpose other than hand-washing as specified in section 20-21.08(b) of this code.
(corrected on site)
20-21.19(a)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
20-21.20(a)(03)
Controlling pests, generally. effective measures intended to eliminate the presence of rodents, flies, cockroaches, and other insects on the premises not utilized.
20-21.21(a)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.
20-21.22(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Cleaning equipment storage. after use, mops not placed in a position that allows them to air-dry without soiling walls / equipment / supplies.
(corrected on site)
20-21.28(e)
Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.
20-53(g)
55
Jun 13, 2025
Routine Inspection (001)
9 minor violations. 2 corrected on site.
View 9 violations
General. the internal temperature of time/temperature controlled for safety (tcs) food not maintained at 41°f (05°c) or below or 135°f (57°c) or above at all times, except as otherwise provided in this article or unless a packaged product is so labeled as exempted and approved by the appropriate state or federal health authority.
(corrected on site)
20-21.02(a)(01)
Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.
20-21.03(b)(01)
Refrigerated storage. methods for rapid cooling. approved methods for rapid cooling not utilized.
(corrected on site)
20-21.03(b)(03)
Materials; general. all equipment and utensils not maintained in good repair.
20-21.10(a)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Floor drains. properly installed trapped floor drains not provided in floors that are water-flushed for cleaning / that receive discharges of water or other fluid waste from equipment / in areas where pressure spray methods for cleaning equipment are used. the floors shall be constructed only of sealed concrete, terrazzo, ceramic tile or similar materials, and shall be graded to drain.
20-21.22(d)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.
20-21.22(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
64
Jul 23, 2024
Routine Inspection (001)
4 minor violations. 2 corrected on site.
View 4 violations
Dispensing utensil not stored in non-time/temperature controlled for safety (tcs) food with the handle above the top of the food within the covered container / equipment.
(corrected on site)
20-21.05(f)(06)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
(corrected on site)
20-21.20(a)(03)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.
20-21.22(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
82
Feb 27, 2024
Routine Inspection (001)
8 minor violations. 2 corrected on site.
View 8 violations
8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.
20-20(c)
Materials; general. multi-use equipment and utensils not designed, constructed and repaired with safe materials, including finishing materials / not corrosion-resistant and nonabsorbent / not smooth, easily cleanable and durable under conditions of normal use.
20-21.10(a)
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Hand-washing sink supplies. supply of hand-cleansing liquid / powder / bar soap not available at each hand-washing sink or group of two adjacent hand-washing sinks.
(corrected on site)
20-21.19(c)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
20-21.20(a)(03)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Labeling of materials. working containers used for storing poisonous / toxic materials such as cleaners and sanitizers taken from bulk supplies not clearly / individually identified with the common name of the material.
(corrected on site)
20-21.27(b)
67
Frequently Asked Questions
When was Taqueria Tepatitlan last inspected?
The most recent health inspection at Taqueria Tepatitlan on file is from Oct 28, 2025. The public record contains four inspections in total.
What is the most common violation at Taqueria Tepatitlan?
Across the inspection record, “plumbing fixture installation” has been cited two times, more than any other issue at Taqueria Tepatitlan.
How does Taqueria Tepatitlan compare to other restaurants in Houston?
Taqueria Tepatitlan most recently scored 55 out of 100, which is lower than the Houston average of 88.
Has Taqueria Tepatitlan's inspection record improved over time?
No. Recent inspections at Taqueria Tepatitlan have averaged around 12 violations per visit, up from roughly six earlier in the record.
What does a medium risk rating mean?
A medium risk rating at Taqueria Tepatitlan means the most recent inspection turned up a handful of issues that the health department wrote up but did not classify as critical.
How often is Taqueria Tepatitlan inspected?
Based on the inspection history on file, Taqueria Tepatitlan is inspected around two times per year on average.
Nearby Restaurants