Zapco #6

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Wiping cloths. moist cloths used for wiping food spills on kitchenware and food-contact surfaces of equipment not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses. (corrected on site)

Hand-washing signage. sign / icon / poster that notifies food employees to wash their hands not provided at all hand-washing sinks used by food employees / not clearly visible to food employees.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Toilet fixtures. easily cleanable receptacles not provided for waste materials.

Utility line/duct installation. exposed utility service lines and pipes not installed in a way that does not obstruct or prevent cleaning of the walls and ceilings. utility service lines and pipes shall not be unnecessarily exposed on walls or ceilings in those areas listed in subsection (b) of this section. service lines behind counters used only for beverage preparation may be exposed on the inside counter walls if necessary for service and if kept to a minimum. if exposed in rooms or areas allowed in subsection (c) of this section, air conditioning / ventilation / heating ducts shall be of smooth rigid metal and designed with a circular cross-section.