Tidwell Food Store

Cross contamination. except as specified in subitem c of this item, food not protected from cross contamination by separating raw animal foods during storage, preparation, holding and display from: raw ready to eat foods including other raw animal food such as fish for sushi or molluscan shellfish or other raw ready to eat food such as vegetables; cooked ready to eat foods. frozen, commercially processed and packaged raw animal food may be stored or displayed with or above frozen, commercially processed and packaged, ready to eat food. (corrected on site)

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Single-service articles. single-service and single-use articles not stored at least six inches (15 cm) above the floor on dollies / pallets / racks / skids designed as specified under section 20-21.03(a)2b of this code / not kept in closed cartons that protect them from contamination, except for automatic fire protection sprinkler heads that may be required by law.

Hand-washing sink supplies. supply of hand-cleansing liquid / powder / bar soap not available at each hand-washing sink or group of two adjacent hand-washing sinks.

Materials; general. sponges. sponges used in contact with cleaned and sanitized or in-use food-contact surfaces.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Toilet room. toilet room not provided with tight-fitting / self-closing / solid doors, which shall be closed except during cleaning or maintenance except that this requirement does not apply to a toilet room that is located outside a food establishment and does not open directly into the food establishment such as a toilet room that is provided by the management of a shopping mall or stadium-type facilities.

Construction. walls, including nonsupporting partitions / wall coverings of toilet rooms and vestibules, not smooth / nonabsorbent / easily cleanable. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Toilet room. toilet room not provided with tight-fitting / self-closing / solid doors, which shall be closed except during cleaning or maintenance except that this requirement does not apply to a toilet room that is located outside a food establishment and does not open directly into the food establishment such as a toilet room that is provided by the management of a shopping mall or stadium-type facilities.

General. food not in sound condition / safe for human consumption / free from spoilage, filth, other contaminants. food prepared in or obtained from an unlicensed private home or other unlicensed food establishment is considered to be from an unapproved source and may not be used or offered for sale for human consumption in or from a food establishment. (corrected on site)

Single-service articles. single-service and single-use articles not stored at least six inches (15 cm) above the floor on dollies / pallets / racks / skids designed as specified under section 20-21.03(a)2b of this code / not kept in closed cartons that protect them from contamination, except for automatic fire protection sprinkler heads that may be required by law. (corrected on site)

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Construction. walls, including nonsupporting partitions / wall coverings of toilet rooms and vestibules, not smooth / nonabsorbent / easily cleanable. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

General. food not in sound condition / safe for human consumption / free from spoilage, filth, other contaminants. food prepared in or obtained from an unlicensed private home or other unlicensed food establishment is considered to be from an unapproved source and may not be used or offered for sale for human consumption in or from a food establishment. (corrected on site)

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.

Cleaning frequency. equipment, food-contact surfaces, and utensils not clean to sight and touch.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

\"no smoking\" signs or the international \"no smoking\" symbol not clearly and conspicuously posted in a public place where smoking is prohibited (corrected on site)

Refrigerated storage. refrigeration facilities. the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of the mechanically refrigerated unit and designed to be easily readable.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Cleaning equipment storage. after use, mops not placed in a position that allows them to air-dry without soiling walls / equipment / supplies.